Single hung
Double hung
Horizontal roller
Casement
Bay & bow
Sliding glass doors
Entry doors
Impact garage doors
PGT
CGIFree in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Get your free estimateCGI Door Installation in North Las Vegas: What to Know First
We are an independent CGI service provider installing entry, French, storm, and hurricane-rated exterior doors in North Las Vegas. Most single-door installs are done in one visit once the door is on site; two-door and custom openings usually take a full day. Expect honest pricing on paper before we start, with both warranty layers registered in writing before the truck leaves your driveway.

This page is for the CGI door owner in North Las Vegas who has a warped slab, a sagging sidelite, or a hinge that no longer lines up, and who wants it handled by technicians who work on CGI frames regularly. Call (833) 734-5506 and a live person will answer, day or night.
How CGI Products Fail – and How We Fix Them
CGI door problems in North Las Vegas tend to follow patterns. Here are the ones our technicians see most often, and what actually causes them.
- Sagging entry slabs on the CGI steel line. In homes where the slab faces full west sun through summer, the door expands and the hinge-side gap opens up. Most retailers call this “settling” and tighten screws. The real cause is usually a bottom hinge screw that has pulled out of the jamb rather than the frame itself moving. We reset the anchors and check the threshold before we touch the hinges.
- Warped astragal on CGI double and French doors. The astragal is the strip between the two leaves, and on CGI double doors the lower section takes on heat warp after a few desert summers. That warp is what stops the inactive leaf from latching. We replace the astragal and re-align the strike rather than forcing the door to close against the warp.
- Failed weatherstripping and threshold sweep. North Las Vegas dust and dry heat crack the kerf-style strip along the jamb and the sweep at the bottom. You get a draft in January and blowing grit in April. We use CGI-compatible kerf stripping cut to the frame, not a universal stick-on strip that peels in two summers.
- Cracked glazing in storm-rated CGI door panels. The seal between glass and sash can fail on impact-rated panels exposed to daily sun. A hazy or weeping edge means the sealed unit is done, not just the caulk. We replace the unit to spec and leave the panel frame intact where it’s still sound.
- Improperly flashed or old retrofit installs. Many CGI doors in North Las Vegas were set into openings with no sill pan and no head flashing. Water tracks behind the jamb during monsoon season, and you find it later as rot in the framing. We pull and reset the door with proper flashing, not just caulk over the top.
What we won’t do is swap in a generic aftermarket slab and call it a CGI door. OEM parts from CGI are the only consistent match for their hinge spacing and stile dimensions, and aftermarket substitutes on their storm-rated panels void the impact rating.
Styles & brands we work with
- Single hung
- Double hung
- Horizontal roller
- Casement
- Bay & bow
- Sliding glass doors
- Entry doors
- Impact garage doors
- PGT
- CGI
Our CGI Door Installation Process
- 1
Measure and inspect. We measure the rough opening and the finished opening twice. We check for framing rot, sill damage, and out-of-plumb jambs before we quote. If the opening is bad, you hear it up front.
- 2
Quote on paper. We give you line-item pricing with the CGI door model, glazing option, hardware, and labor separated. We quote manufacturer lines side by side on paper so you see exactly what you’re buying. No surprise line items when the job closes.
- 3
Parts decision. OEM where the warranty and fit require it. Quality aftermarket flashing and sealant where it does the job better and doesn’t touch the warranty. We tell you which is which in writing.
- 4
Install. We pull the old door, set the new frame, flash the sill and head, shim and level, and secure the hinges. Our technicians have up to 18 years of experience, and every one of them is background-checked and uniformed.
- 5
Test and adjust. We open and close the door through a full swing, check the latch and deadbolt line up, and verify the weatherstrip seals against the frame. If it binds, we fix it before we leave.
- 6
Register both warranty layers. Under The Keystone Standard, we register both manufacturer warranty layers in writing with durations stated before the truck leaves the driveway. Our workmanship is covered by the 90-Day Done Right Promise.
What CGI Door Installation Costs in North Las Vegas
Most CGI door installations in North Las Vegas land in these ranges. Your exact number depends on door size, glazing, and what we find when we pull the old door.
| Job | Typical price range |
|---|---|
| Single CGI entry door, standard size, like-for-like swap | $1,400 – $2,600 |
| CGI French or double door, reusing existing opening | $2,600 – $5,200 |
| Hurricane-rated CGI entry door, impact glazing included | $2,800 – $4,500 |
| Replacement door in an opening needing flashing or framing repair | $600 – $1,500 added to base |
| Astragal or weatherstrip replacement, labor included | $220 – $480 |
What moves the price: door size (custom widths raise the number), glazing type, hardware grade, and whether the rough opening needs repair. Call (833) 734-5506 for your free estimate – it’s a written quote with nothing hidden in it.
See the difference
Before
After
Before
After
Before
AfterWhy North Las Vegas Homeowners Call TruePane Windows & Doors North Las Vegas for CGI Work
Most of our North Las Vegas customers are looking for the last call they’ll need to make on a door. Here’s what that looks like with us. The 90-Day Done Right Promise means if something isn’t right, we come back and fix it – no paperwork, no arguing. We’ve proudly served local communities for over 42 years through a heritage of craft commitment, and we plan to still be here when your warranty matters.
We’re an authorized installer for more than a dozen manufacturer lines, including PGT, CWS, ES Windows, and ECO Window Systems alongside CGI. That’s useful when a CGI part is out of stock or a homeowner wants to compare options. Our CGI work itself is independent – we’re not affiliated with or authorized by CGI as a manufacturer.
FAQs
Does installing a CGI door through an independent installer affect my CGI warranty? No, as long as the install follows CGI’s published guidelines and uses warranted parts. We handle this by registering both warranty layers in writing with durations stated before we leave, so you have the paperwork in hand.
How fast can you install a CGI door in North Las Vegas? Most standard CGI entry door swaps are completed in a single visit once the door is on site. Custom and hurricane-rated doors need lead time from CGI. Call (833) 734-5506 for the current timing on your specific door.
Can you get CGI OEM parts, or do you use aftermarket? We use OEM CGI parts wherever the warranty or fit requires it, and quality aftermarket flashing and sealant where they do the job better without affecting your warranty. You’ll see the difference on the written quote.
Is it worth repairing my CGI door, or should I replace it? Repairs make sense for warped astragals, failed weatherstrip, and pulled hinge screws. If the slab is warped past a reset, or the frame has rot, replacement is the honest call. We tell you which based on what we find during the measurement.
Will the price change once work starts? Only if we find framing damage behind the old door, and we call you with a written change before touching it. No surprise line items on the bill.
Get a Free Estimate on Your CGI Door in North Las Vegas
Whether you’re in the older neighborhoods off Civic Center Drive or a newer build out near Aliante, a CGI door install done right is one less thing on your list. Our technicians measure every opening twice, quote manufacturer lines on paper, and back the work with the 90-Day Done Right Promise and The Keystone Standard. Call (833) 734-5506 for your free estimate – a live person answers 24 hours a day, 7 days a week. If the pane is not true, the job is not done.
Written by the team at TruePane Windows & Doors North Las Vegas, serving North Las Vegas and nearby areas.